Calibration Doesn't Line Up with Table

If the projected image doesn't align with your pool table surface, follow these troubleshooting steps to fix calibration issues.

Symptoms

• Projected image doesn't align with table edges
• Image is rotated or skewed

Likely Causes

• Mounting position incorrect: Projector not centered or at wrong angle
• Calibration needs adjusting.

Fix Steps

1. Verify mounting position: Projector should be centered within the side rail (for vertical and side mount) or within the end rail (for end mount). For side and end mount the projector must be at the proper angle. Check mounting location and orientation is correct.
2. Disable the projector's built-in digital keystone (if enabled): ICATS handles alignment internally and is not compatible with projector keystone correction.
3. Set the projector's built-in digital zoom to 1.

Still Not Working?

Still stuck? If calibration issues persist:

• Review mounting installation
• Verify projector meets requirements
• Contact Support with photos of your setup